Skip to content

1-Wire LoRaWAN Bridge (Temperature Sensors)



Firmware Release Notifications

We normally send e-mail notifications upon release of new firmware versions. To receive this mails you can sign up to the Lobaro newsletter here.

Subscribe to our email newsletter here

Make sure to select the "Firmware Updates" checkbox!


0.4.0 - 2020-06-30


  • Use lobawan stack v1.2.2
  • Sensors from SensorIdOrder that are missing will still be uploaded (with -0x8000 value)
  • When SendSensorId==false uploads are done on port 3 (was port 2),
  • Enable 3.3V step-up only if voltage is below 3.1V (was: if below 3.3V).
  • Support up to 32 sensors (only 25 supported in SensorIdOrder).

0.3.3 - 2019-08-01

  • Added ADR config parameter

0.3.2 - 2019-08-01

  • Fixed Onewire init after DeepSleep

0.3.1 - 2019-07-29

  • Temp sensors will be printed and sent sorted by parameter "SensorIdOrder" and by ID or just by ID if parameter "SensorIdOrder" is empty

0.2.0 - 2019-02-15

  • Add parameter "SendSensorId" to allow skipping sensor IDs in payload


  • Bugfixes in LoraWAN stack
  • LoRaWAN Support for RX1 DataRate Offset


  • Don't send sensor type with ID (support 6 sensors in 50 bytes)
  • Add TestMode config value
  • Add SendInternalTemp config value
  • Internal sensor is send first if SendInternalTemp = true